Do not use chemical solvents to clean the surface of the unit.
Use a clean damp cloth.
Check the Air lter every week. (Fig 4)
Remove the air lter, the element may be vacuumed clean or
washed in a neutral and detergent mix (40°C).
Rinse and dry the lter before replacing.
Do not dry in direct sunlight.
1. Clean Filter.
2. Clean surfaces.
3. Drain water from unit. Please note water will drain from
the low level water drain ( g5) when the stopper is removed.
Run in fan mode until the pipe is dry.
DO NOT DO THIS ON ANY INDOOR FLOOR SURFACES.
4. When the unit is clean and drained, store in a clean, dry
area. Stow cable.
Getting Started and Operation
Never operate the unit in very hot or cold conditions – it
works properly at temperatures between 16°C and 31°C.
Always allow the unit to stand/settle for 15 minutes before
switching on when either setting or restarting.
Position the mobile air conditioner in a at location where
the air outlets cannot be covered up. Place the unit no less
than 50cm away from a wall or other obstacle.
Fit the square end of the exhaust duct to the exhaust
terminal of the unit ( g 1)
Put the other end (discharge) out of the nearest window.
The length of the air exhaust between 600 – 2000mm. Use
the minimum length when working. When mounting, try
and keep the air exhaust hose vertical or horizontal, sloping
up or down. Never operate if the hose is kinked or sagging.
If mounting exhaust duct through a wall, the height of the
hole should be 40 – 130cm.
Portable air conditioning (2 pages)
Single phase 230v (28 pages)
Andrews polar wind portable air conditioning operating instructions & safety guide (2 pages)
Portable air conditioning (2 pages)
Cooling model only (2 pages)
Portable air conditioning (2 pages)
Double cool portable air conditioning (2 pages)
Heat pump air conditioner (2 pages)
Portable air conditioning (2 pages)